+- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum)
+-- Forum: Tiara Yachts Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=6)
+--- Forum: General Repairs & Maintenance (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=10)
+--- Thread: Zinc needed (/showthread.php?tid=2750)
Zinc needed - Ohana John - 03-21-2016
I own a 2001 Coronet that I purchased last year. This is the first year that I'm purchasing Zincs for the boat. Does any one have a list of the zincs needed?
Sent from my iPhone using Tapatalk
RE: Zinc needed - rafredrickson - 03-26-2016
E1 pencil for the engines, E0 for the genny, 1/1/2' shafts, and 5 bolt center plates for thetransom
RE: Zinc needed - stugiv - 04-21-2016
I have a '97 so I'm not sure if there were any changes.
I use E0 pencil zincs on the U cooler & E1 for the heat exchanger. My hull zincs are CMMZC406, which is the Martyr part #. Not sure what the generic size is. I also added some BNT-1 zincs on the Bennet trim tabs because I was having some electrolysis problems.