+- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum)
+-- Forum: General Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=3)
+--- Forum: Tiara Yachts Model Discussion (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=24)
+--- Thread: Tiara Parts (/showthread.php?tid=357)
Pages:
1
2
Tiara Parts - candahector - 04-08-2013
I recently purchased a 1991 Tiara 31 Open. It need a lot work, so I'm in need of finding a parts supplier for this type and model Tiara. Any good sources out there? I'm in the South Florida area.
Tiara Parts - Chris Burkard - 04-08-2013
Candahector,
Welcome! The Tiara 31 is a great boat. As far as parts suppliers, it all depends on what parts you are trying to locate. A Tiara dealer can certainly help, but the pricing is likely to be higher than if you locate them directly from the manufacturer or from a high volume parts dealer such as Port Supply.
If you can do the research to find the original manufacturers, it will be easier to track the parts down. Let us know what you are looking for and perhaps we can help.
Sincerely,
Tiara Parts - trit21 - 04-09-2013
Not sure where in So FL you are but my boat is in Ft Pierce and a lot of stuff on the my Tiara at least (2000 3500 Open) can be had off the shelf at West Marine. LIke Chris mentioned, it depends on what you are looking for as well. has many liquidation parts that can be had at a fair price as well and I am sure in your area there are other place that also offer parts like this.
Tom
Tiara Parts - Persistence - 07-09-2013
I might be looking for the plastic cover that goes over the 31's wet bar / prep station. or, how to repair it. I got a nice crack across the aft edge after it slammed down last week. i'm just happy it didnt catch someones hands.
thanks
Tiara Parts - Chris Burkard - 07-10-2013
The wet bar lid is a Tiara specific part. I'm not sure that Tiara even offers it anymore. Your best bet would be to pull the old part and locate a plastics company and have it duplicated. I had one made here in Naples, FL for a 31 Open at a company called Plastic Specialties. I think it was $70.00 or so.
Tiara Parts - Persistence - 07-10-2013
thanks again. Tiara did tell me it was replaced at least once on my boat. sounds like people have a habit of sitting on it also. oh well. id like to try to glue or trim off the after edge. and replace later. maybe a winter project.
Tiara Parts - Chris Burkard - 07-11-2013
That lid is made from an acrylic sheet. If you glue it, make sure you use an acrylic cement. All other glues won't stick to the acrylic. The acrylic cement actually melts the acrylic and bonds it chemically together.
Tiara Parts - Uhehner - 07-11-2013
If you are worried about it breaking again get some Lexan. It's near impossible to break. Capt. George
Tiara Parts - Uhehner - 07-11-2013
I did lots of repairs and upgrades on my 31' and 36' Tiaras. I live in South East Florida and can advise you if you post what you need. Capt. George
Tiara Parts - alcord - 05-30-2015
Capt George where can I buy exhaust and manifold 454
Sent from my iPad using Tapatalk