+- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum)
+-- Forum: Tiara Yachts Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=6)
+--- Forum: General Repairs & Maintenance (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=10)
+--- Thread: 2007 Tiara Sovran 4300 Selector switch question (/showthread.php?tid=6107)
2007 Tiara Sovran 4300 Selector switch question - fulltilt06 - 06-18-2019
I just purchased recently a Sovran 4300 and I was not given but a few instructions on the boat when I took possession. This forum has been great for answering a few but the one I am puzzled with is this. When I open the door in the cabin to start the generator. There is a selector switch that goes from Generator, Off and engine. Could someone please explain what this is for?
2007 Tiara Sovran 4300 Selector switch question - Misdirection - 06-18-2019
Are you sure it's not generator, off, and shore?
When in the Shore power position, you are powering the AC electric to your boat from your shore power cord that is plugged into the pedestal. When in the off position, no AC power is being supplied to the boat. When in the generator position, if your generator is running, power to the boat will come from the generator.
As a side note, you should always put the switch into the off or generator position before unplugging / plugging in the shore power cord.
Sent from my XT1635-01 using Tapatalk
RE: 2007 Tiara Sovran 4300 Selector switch question - egstasea - 06-18-2019
It is just the selector switch for the DC panel Meter.
RE: 2007 Tiara Sovran 4300 Selector switch question - fulltilt06 - 06-18-2019
(06-18-2019, 10:29 AM)egstasea Wrote: It is just the selector switch for the DC panel Meter.
Thanks for the reply. So it is just showing me DC voltage for what is selected?
RE: 2007 Tiara Sovran 4300 Selector switch question - egstasea - 06-18-2019
(06-18-2019, 03:06 PM)fulltilt06 Wrote:
(06-18-2019, 10:29 AM)egstasea Wrote: It is just the selector switch for the DC panel Meter.
Thanks for the reply. So it is just showing me DC voltage for what is selected?
Yes