![]() |
|
[Tiara Open] AC Question - Printable Version +- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum) +-- Forum: Tiara Yachts Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=6) +--- Forum: AC/Heat, Plumbing & Sanitation (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=29) +--- Thread: [Tiara Open] AC Question (/showthread.php?tid=6717) |
AC Question - Ty1on - 03-20-2020 Hello fellow boaters , I just purchased a 3100 open -2003 late last year . so still trying to figure it all out. theres lots more to it than my old searay. Anyway, can someone tell me ..when my AC unit is running it does not always pump water is that normal? or do I have a problem? Thanks for any feed back. Tyler AC Question - Misdirection - 03-20-2020 Your pump should be running when your compressor is running. Typical cycle is the fan kicks on, determines heat/cooling is required. If so, the water pump is activated. Once water flow is detected, the compressor will kick on. So I suspect everything is normal. On older units, the water pump ran continuously. Sent from my SM-A505U using Tapatalk RE: AC Question - ReelMagic - 03-20-2020 I have 2 A/C units on my 38 Open and had 1 unit on my previously owned 1997 31 Open.. When ever the A/C unit comes on, for heat or cooling, the A/C pump starts and stays on till the unit shuts off (temp reaches set point)... M2C RE: AC Question - trit21 - 03-20-2020 Is it just the circulation fan that is running or is the compressor on? My AC fan runs all the time but circulates water only when the compressor kick on, which is normal. You can adjust the fan to run continuously or just when the compressor turns on. RE: AC Question - jclark003 - 03-20-2020 Assuming you have a MarineAir unit if compressor is running with no water flow the display will flash "HHH" for high head pressure and the compressor will shutdown (no cool or heat). Previous posts are correct in that unless configured differently, fan remains on to constantly circulate air. |