+- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum)
+-- Forum: Tiara Yachts Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=6)
+--- Forum: General Repairs & Maintenance (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=10)
+--- Thread: PSS Shaft Seal Replacement/Drive shaft removal (/showthread.php?tid=6878)
PSS Shaft Seal Replacement/Drive shaft removal - expresslife - 06-09-2020
Hello everyone,
I recently purchased a 2000 Tiara 3500 Express with twin 8.3L Cummins and ZF 302 Transmissions. With that being said, we ran over a log causing the port PSS Seal to leak due to a fracture in the carbon. We have all the parts ready to go on, but we are in trouble working to get the driveshaft removed in order to replace the part. Mechanic has tried 10,000 LB of pressure along with heating it but still no budge. Are we missing a bolt or anything? Does anyone have any recommendations or a step by step removal for the ZF 302 v-driveshaft? Anything will help!
Thanks Tiara Team!! In need of this help!!
PSS Shaft Seal Replacement/Drive shaft removal - bsause - 06-09-2020
Can you send pic ?
I just had my seals replaced. My mechanic had to make a special socket to get shaft out from coupler.
Pain in the a**. I get it.
Sent from my iPhone using Tapatalk
RE: PSS Shaft Seal Replacement/Drive shaft removal - jclark003 - 06-09-2020
If you can't get help here try boatdiesel.com. I've seen this come up a few times there and a lot of good mechanics on that site.
Not clear where you are having problems. Is it removing the coupler from the shaft or separating the coupler from the transmission output flange?
RE: PSS Shaft Seal Replacement/Drive shaft removal - reeltimebrad - 06-11-2020
You have to remove the coupler nut and washer and then mount a puller on the coupler which drives the shaft out of the coupler same taper setup as a prop. It takes alot of pressure the puller plate needs to be 5/8 or thicker steel to not bend! Then apply heat to the coupler with Mapp gas it will need to get very hot and melt the paint off usually.