38 open 2001 Clamp-on rod holders - Printable Version +- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum) +-- Forum: Tiara Yachts Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=6) +--- Forum: General Repairs & Maintenance (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=10) +--- Thread: 38 open 2001 Clamp-on rod holders (/showthread.php?tid=6914)

38 open 2001 Clamp-on rod holders - OurHighLife - 06-25-2020 Hi gang, What is the diameter of the grab rail on the stern of a 2001 38 open & the grab rails on the side of the Tiara radar arch? I would like to install a couple of clamp on rod holders. Thanks, Andy 38 open 2001 Clamp-on rod holders - bsause - 06-29-2020 My guess is @ 1” Sent from my iPhone using Tapatalk 38 open 2001 Clamp-on rod holders - storman - 07-19-2020 I believe they are 7/8 or 1" I went through a couple of pairs and ended up with cisco rod holders out of ohio. The tube holders can be rotated 360* and tilt up and down. I mounted two on port and 2 starboard on rail mounts for planer board rods for salmon. Could not be happier. I will try to find my receipt to verify the diameter I think they custom made the clamps to my diameter. The off the shelf taco marine holders were either under or over the diameter I needed. I will be back on the boat friday and will take a pic of my set up. Sent from my SM-N970U using Tapatalk RE: 38 open 2001 Clamp-on rod holders - OurHighLife - 07-19-2020 Thanks so much 38 open 2001 Clamp-on rod holders - storman - 07-25-2020 Cisco tube holders rotate 360* and tilt up and down with no tools. Sent from my SM-N970U using Tapatalk