+- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum)
+-- Forum: Tiara Yachts Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=6)
+--- Forum: General Repairs & Maintenance (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=10)
+--- Thread: Scupper Flange Replacement on 2006 3200 (/showthread.php?tid=6017)
Scupper Flange Replacement on 2006 3200 - MichFan - 05-05-2019
Just noticed a crack and missing piece in black external scupper flange on hull side. Looking for help on a couple questions.
Does anyone know a good source for this part ( I will also call Tiara tomorrow)? Can anyone help with replacement tips? Is this a cosmetic piece or does it require rebedding? Thanks for the help.
Sent from my iPhone using Tapatalk
RE: Scupper Flange Replacement on 2006 3200 - Matta0413 - 05-06-2019
It is not cosmetic. You will need to replace the entire scupper, inside and out. I replaced mine two seasons ago. Not a terribly tough job. You will most likely need to break the old ones to get them out. I used APF Marine group. They were half the cost of Tiara and the parts and service were both great. They say you should replace them every 10-15 years or so anyway to make sure there is no moisture getting in.
Scupper Flange Replacement on 2006 3200 - MichFan - 05-06-2019
Thanks for the reply. I did also talk with Tiara today and they said I was able to replace the flange alone and not disturb the rest of the assembly. They are shipping a part, but based on your comments It sounds like I may need more parts. I’ll be down there this weekend to try and disassemble and see what needs to be done. Thanks again for the response.
Sent from my iPhone using Tapatalk
RE: Scupper Flange Replacement on 2006 3200 - Matta0413 - 05-06-2019
Yours is 4 years newer than mine so i guess that could be if they changed something. When I called them they told me the entire scupper needed to be changed.