Tiara Yacht Owners Forum
water strainers question - Printable Version

+- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum)
+-- Forum: Tiara Yachts Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=6)
+--- Forum: General Repairs & Maintenance (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=10)
+--- Thread: water strainers question (/showthread.php?tid=761)



water strainers question - sluggo - 07-07-2014

how to you open the to pull out the basket? I have the Groco ARG series straines circa 2006 on my 3600 Sovran. I dont see an easy way to open them to clean them out. Is there a special wrench?? Thanks in advance.


water strainers question - Uhehner - 07-07-2014

You need a Spanner Wrench. (Groco Wrench Spanner/Deck Plate GRO-SW2531). Try West Marine or E-Bay. About $15-20. Capt. George


water strainers question - sluggo - 07-07-2014

Quote:Uhehner - 7/7/2014 3:45 PM

You need a Spanner Wrench. (Groco Wrench Spanner/Deck Plate GRO-SW2531). Try West Marine or E-Bay. About $15-20. Capt. George

Thanks!! LOL I have one, found it in the chart locker, I thought it was some sort of compass/chart dividers!!! I assume I will see the holes where you place this, and said holes are on top of the strainer.


water strainers question - Jakes - 07-07-2014

You will easily see how to use the wrench. You may want to shut off the water suppy to the strainer before opening the cap.


water strainers question - sluggo - 07-08-2014

Quote:Jakes - 7/7/2014 4:09 PM

You will easily see how to use the wrench. You may want to shut off the water suppy to the strainer before opening the cap.

thanks!! I got it to work!!


RE: water strainers question - Tgilbert - 02-11-2020

Do you have to close thru-hulls before opening and inspecting strainers?


RE: water strainers question - Sans Peur - 02-12-2020

(02-11-2020, 09:02 PM)Tgilbert Wrote: Do you have to close thru-hulls before opening and inspecting strainers?

YES! Definitely. Unless you want to rinse out the inside of your engine room. The strainers are below the waterline. Open them up and you just open at least a 2" hole in the bottom of your boat.