+- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum)
+-- Forum: General Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=3)
+--- Forum: Tiara Yachts Model Discussion (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=24)
+--- Thread: Beeping sound at increased speed (/showthread.php?tid=8315)
Beeping sound at increased speed - Doghouse1 - 06-18-2022
After moving on plane there is a beeping sound all gages are normal
After decreasing speed sound will slow down and stop when Idling
RE: Beeping sound at increased speed - MC1600 - 06-18-2022
Is it the same sound you get when you first start up? If so, I’d start with examining oil pressure. Don’t trust the gauges at the helm and toss a mechanical gauge on the motor to rule that out.
RE: Beeping sound at increased speed - Doghouse1 - 06-20-2022
Thanks for info. When I tip console back two alarms one on starboard one on port right side alarms when keys are on port side is the alarms while underway
Beeping sound at increased speed - Misdirection - 06-20-2022
Not knowing what motors you have, but if you have gas motors, the engine alarm goes off for one of three reasons.
Oil pressure, engine temp, or transmission temp.
First things first. Check your oil, and transmission fluid levels. If their fresh water cooled, check antifreeze levels.
Sent from my SM-S901U using Tapatalk
RE: Beeping sound at increased speed - Doghouse1 - 06-20-2022
6bta5.19 Cummins
I’ll check what you said thank you
Beeping sound at increased speed - Misdirection - 06-20-2022
Ok, I'm not sure anything I provided applies to diesel's, but that would still be a good place to start.
Sent from my SM-S901U using Tapatalk
RE: Beeping sound at increased speed - Doghouse1 - 06-20-2022
Thanks to all it was a loose ground bus bar
Regards
RE: Beeping sound at increased speed - bhaslehurst - 06-04-2023
(06-20-2022, 06:25 PM)Doghouse1 Wrote: Thanks to all it was a loose ground bus bar
Regards
I have the same engines and an intermittent alarm going off when on plane. All my gauges are reading good. Where did you locate the loose ground? Thanks