Tiara Yacht Owners Forum
Water tank level sensors - Printable Version

+- Tiara Yacht Owners Forum (https://www.tiaraownersclub.com/forum)
+-- Forum: Tiara Yachts Discussion Forum (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=6)
+--- Forum: AC/Heat, Plumbing & Sanitation (https://www.tiaraownersclub.com/forum/forumdisplay.php?fid=29)
+--- Thread: Water tank level sensors (/showthread.php?tid=9178)



Water tank level sensors - Final Pursuit - 08-14-2025

2006 3600 Sovran. The tank watch system shows full and empty lights at the same time for the water tank. I wanted to look at the sensors but I’m not sure how they come out. There’s plastic with a seal around it that goes into the tank. Do you pry the plastic out or the seal that goes into the tank? I have attached a photo.


RE: Water tank level sensors - Roweje - 09-16-2025

(08-14-2025, 06:39 AM)Final Pursuit Wrote: 2006 3600 Sovran. The tank watch system shows full and empty lights at the same time for the water tank. I wanted to look at the sensors but I’m not sure how they come out. There’s plastic with a seal around it that goes into the tank. Do you pry the plastic out or the seal that goes into the tank? I have attached a photo.

I don’t see any pictures?


RE: Water tank level sensors - Final Pursuit - 09-17-2025

Sorry- I could not get picture to post. However I did find the sensors could be prayed out of the surrounding rubber ring, then remove the ring in order to allow removal of sensor.


RE: Water tank level sensors - Roweje - 10-06-2025

(09-17-2025, 06:35 AM)Final Pursuit Wrote: Sorry- I could not get picture to post. However I did find the sensors could be prayed out of the surrounding rubber ring, then remove the ring in order to allow removal of sensor.

Did you ever get the sensors to read correctly? If so, what was the fix?


RE: Water tank level sensors - Final Pursuit - 10-09-2025

The sensors are available from Raritan. I ordered one thru Marine Parts Source. They pry out of the rubber grommet,then you have to remove the grommet in order to remove the sensor. The magnet at the end can be moved to test functionality.