Posts: 51
Threads: 14
Joined: Sep 2018
Reputation:
1
Home Port: Hope Port-Newport Beach, CA and we boat in So Cal and Northern Baja.
Vessel Info: 2002 4100 Open, Cats 3126B 450 HP.
I have a 2002 4100 Open and the Sealand head pump has an intermittent issue. It became worse after a cruise with kids and I'm not sure if it's related.
Sporadically the pump used to come on for 2-3 seconds throughout the day. After the kid trip, it comes on for several minutes and periodically won't shut off. I have been flushing the head to see if it would reset and sometimes it works and other times I shut it off at the panel. After several minutes off, I turn it back on and it stops running.
Is this a problem with the pump, accumulator, lines or??? Before I replace everything, I would like to know if you folks have had this issue and what you did to resolve it.
Thanks in advance,
Tim
Posts: 705
Threads: 14
Joined: Dec 2010
Reputation:
11
Home Port: Kings Park, NY
Vessel Info: 2003 38' Open Cummin's 6CTA's (450 hp)
Assume you have a vac-u-flush system on your boat. If so I suspect the "duckbill valves" are leaking causing a vacuum leak... I've attached a diagram to show where they are.. The duckbills get clogged/old after several years and no longer seal as intended.. As a result they leak preventing the system from holding a vacuum.. Replace is my suggestion... M2C
Posts: 481
Threads: 8
Joined: Apr 2018
Reputation:
10
Home Port: Port Canaveral, FL
Vessel Info: 2003 Tiara 50 Open
3406E Cats
Buy the replacement duckbill kit along with the new silent diaphragm and replace everything. Once you pull the pump apart you will immediately know if it was the kids fault or just old duck bills. If something is stuck in the duck bills it was the kids (or a parent) if not it was age.
Posts: 51
Threads: 14
Joined: Sep 2018
Reputation:
1
Home Port: Hope Port-Newport Beach, CA and we boat in So Cal and Northern Baja.
Vessel Info: 2002 4100 Open, Cats 3126B 450 HP.
04-12-2019, 09:54 AM
(This post was last modified: 04-12-2019, 10:13 AM by hookup44.)
Thanks for the advice. I will tear in down next week and start with the duck bills.
ReelMagic, once again thank you!
I found the duckbills and seals at Amazon and they'll be here Wednesday.
Posts: 705
Threads: 14
Joined: Dec 2010
Reputation:
11
Home Port: Kings Park, NY
Vessel Info: 2003 38' Open Cummin's 6CTA's (450 hp)
Good luck. Should fix.....
Posts: 163
Threads: 12
Joined: Dec 2016
Reputation:
0
Home Port: South haven,mi
Vessel Info: 2006 3200 0pen 8.1 crusaders
I had same issue and after replacing duckbills and the discharge hose it still kept running every 20-30 minutes with no lose of water in the bowl. Long story short ended up being the orings in the flush pedal ball shaft.
Posts: 163
Threads: 12
Joined: Dec 2016
Reputation:
0
Home Port: South haven,mi
Vessel Info: 2006 3200 0pen 8.1 crusaders
Yes it's item #8 a brass shaft attached to the flush ball with two small orings. I would plan on replacing the shaft and orings as mine had some corrosion and pitting. Use silicone or dielectric grease during reassembly.
Posts: 51
Threads: 14
Joined: Sep 2018
Reputation:
1
Home Port: Hope Port-Newport Beach, CA and we boat in So Cal and Northern Baja.
Vessel Info: 2002 4100 Open, Cats 3126B 450 HP.
Thank you for the information. I'll order the part tomorrow and hope this solves the leak.