Posts: 3
Threads: 2
Joined: Jun 2020
Reputation:
0
Home Port: Minnesota
Vessel Info: 2003 Tiara 2900 Coronet
Does anyone have a 2900 Coronet on a trailer so that they could tell me how far apart I should space my trailer bunks. Or even a picture of the bottom of the boat. I have a fully adjustable aluminum trailer, but since the 2900 I purchased is in the water, I can't measure to setup the trailer bunks. Any help would be greatly appreciate. Troy/MN
Posts: 463
Threads: 3
Joined: May 2018
Reputation:
7
Home Port: Ashtabula, OH
Vessel Info: 1986 Tiara 3600 Open, Crusader 454's
Your best bet might be to take the trailer and boat to a marina with a crane and have them lower and adjust the first time. Takes the guesswork out of it and it will cost less than if you make a mistake. Just a suggestion.
Sent from my SM-A505U using Tapatalk
Posts: 3
Threads: 2
Joined: Jun 2020
Reputation:
0
Home Port: Minnesota
Vessel Info: 2003 Tiara 2900 Coronet
not really affordable at my inland lake. Was hoping someone had one on a trailer in this forum.
Posts: 163
Threads: 12
Joined: Dec 2016
Reputation:
0
Home Port: South haven,mi
Vessel Info: 2006 3200 0pen 8.1 crusaders
Find where your thru-hull intakes and transducers are inside the boat and adjust the bunks accordingly. Just going from someone else's setup would be risky as the transducers are often a dealer installed item and location will vary greatly, as will any options such as livewell pickups.
