Posts: 43
Threads: 15
Joined: Jul 2019
Reputation:
0
Home Port: Chesapeake Bay
Vessel Info: 3800 Open Cummins 6CTA8.3
Has anyone removed the stainless steel base of the dinette table? It’s held in by 8 screws I believe, but I don’t know of Tiara used adhesive to affix it to the teak floor. Anyone that has removed this table and can advise it’s appreciated.
Posts: 702
Threads: 14
Joined: Dec 2010
Reputation:
11
Home Port: Kings Park, NY
Vessel Info: 2003 38' Open Cummin's 6CTA's (450 hp)
I removed the table/base several years ago as there is a trhough bolt that limits the table when you raise it.. That bolt broke and I replaced it... Easy job but willl take at least 2 to do the job...
Posts: 43
Threads: 15
Joined: Jul 2019
Reputation:
0
Home Port: Chesapeake Bay
Vessel Info: 3800 Open Cummins 6CTA8.3
Very helpful thx! Was worried Tiara used adhesive to secure it with the screws. That would have been a nightmare.
Posts: 246
Threads: 4
Joined: Nov 2021
Reputation:
12
Home Port: Newport
I have removed as well, comes right up, no adhesive. I found it easy to do alone, not sure why it would take two people?
