Posts: 3
Threads: 1
Joined: Jul 2026
Reputation:
0
Home Port: Alabama
Vessel Info: 2003 Tiara 4000 Express with Cummins 6cta 8.3 480 CE
I have a 2003 Tiara 4000 Express that is in pristine condition. I recently discovered that the port bow has wet core. I sucked about 4 gallons of water out of it last weekend. Additionally the front half of the port side is delaminated from the core but I don’t believe there is any wet core in those areas. Anyone have a similar problem? Boat yard says they need to cut and remove the outer hull and replace core and address delaminated sections that are not wet. Looking for help on this if anyone has had a similar problem.
Posts: 251
Threads: 4
Joined: Nov 2021
Reputation:
12
Home Port: Newport
If it is delaminated then it is almost certainly wet. Unfortunately, this can turn into a can of worms and you likely will not know what you're in for until they start opening it up. Good luck.
Posts: 251
Threads: 4
Joined: Nov 2021
Reputation:
12
Home Port: Newport
If it is delaminated, I would bet 100:1 it is either currently wet or was wet at one point. There is a company called 'Dry Boat' that dries wet coring by forcing air through the wet core. Of course it won't fix any delamination. Perhaps it was wet but dried by that process.
Posts: 80
Threads: 14
Joined: Aug 2020
Reputation:
2
Home Port: Boston, Ma.
Vessel Info: Tiara 40 Express
Cat 3208's
This post make me nauseous. This could easily swell to amounts greater than the value of the boat. Be sure to report back.
Posts: 251
Threads: 4
Joined: Nov 2021
Reputation:
12
Home Port: Newport
I have seen quotes from well regarded yards to invasively open up the hull, repair wet coring, replace the outer skin, and paint the boat, and it was actually significantly less expensive than I imagined. Painful for sure, but still worth fixing.