Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3100 open batteries '94
#1
Hello, wondering if someone can help explain my batteries. I have 7. 3 for a xantrex inverter, I replaced them last year. I'm pretty sure I need the 4 mains now. But I'm not sure how they're wired. And what's eng vs house. Is this a common setup? I have 2 24's and 2 27 deeps I think. They are paired together. And the fwd pair has a red cable labeled stbd while the aft pair is labelled port. Not the best pics billy should give an idea. Thx. [Image: d9ad3f71269b7e146f53924c7b306945.jpg]

[Image: 8e1588669d5f69a47839c644e23e40c2.jpg]


Sent from my iPhone using Tapatalk
Reply
#2
The deep cycle batteries are your house batteries/starting batteries.. The other two are starting batteries.
You have two 12 volt batteries in parallel for each engine. These are the 4 short jumper cables. Red (+) to Red to Red engine cable and Black (-) to Black to the Black engine ground point. The light weight red wires should be going to your battery charger. There should also be a heavy Black wire connecting the two engine ground points together.
Mark all the wires. Turn off your battery charger. Then for safety sake, disconnect the black leads first, then the red leads. 
Reconnect the red leads and then the black leads.
 You should be good to go.
Capt. George
 
Reply
#3
Thx I want to replace all 4. I was thinking 4x 27 deep cycles. Should I just replace with the same size batteries? So the 2 deep are house and 1 motor? And the interstates are just staring to port, or both motors?


Sent from my iPhone using Tapatalk
Reply
#4
You want  two starting batteries for the port engine and two deep cycle for the stbd. engine and house. There is no need for four deep cycle batteries. A starting battery will crank your engine much faster than a deep cycle will. Just replace exactly what you have. Capt. George
Reply
#5
Thx! That's what I got on order. I like the same if it's working Smile


Sent from my iPhone using Tapatalk
Reply
#6
One more question.... The 27 cranking bats don't fit in my trays. Rather thAn replacing the trays should I just get 2 24's? Or cut the aft
Lip off the tray and keep the 27's? Thx


Sent from my iPhone using Tapatalk
Reply
#7
Two 24's should be more than enough to crank over a 454.  Capt.  George
Reply
#8
Agree done installed. Funny also, new port batteries fixed my windshield motor too. Wasn't working before I replaced them. Live and learn! Thx


Sent from my iPhone using Tapatalk
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  [Tiara Open] Main DC Breaker for 1995 Tiara 36 Open petrienorris@gmail.com 3 1,513 10-26-2026, 08:09 PM
Last Post: gracewilson
  1988 3300 Open - Voltage drop when lowering engine hatch or honking horn Pluto 3 1,445 03-24-2026, 09:46 AM
Last Post: hiccup
  Replacing Inverter on 1998 Tiarra 3100 Pknappe 1 639 03-24-2026, 09:36 AM
Last Post: hiccup
  2001 3100 open generator runs but doesn't generate electricity lakesidevu 5 2,844 11-14-2025, 01:01 PM
Last Post: hiccup
  [Tiara Open] 2005 TIARA 2900 OPEN DC ELECTRICAL SCHEMATIC COPY HIGH SPIRTED 2 2,871 07-05-2025, 12:54 PM
Last Post: HIGH SPIRTED



Users browsing this thread: 1 Guest(s)
Advertisements

Latest Threads
3500 Open deck lift piston
Last Post: drmiagi11
Yesterday 12:51 PM
» Replies: 3
» Views: 1015
Hot Engine Room
Last Post: Nelsond
11-04-2026 11:36 AM
» Replies: 0
» Views: 56
Anyone using a cordless robot on a Tiara...
Last Post: thomasbrown
11-03-2026 05:08 PM
» Replies: 0
» Views: 58
Anyone using a cordless pool cleaner wit...
Last Post: hiccup
11-02-2026 01:18 PM
» Replies: 1
» Views: 92
Replacing the head on a Tiara 3100 — do ...
Last Post: hiccup
11-02-2026 01:17 PM
» Replies: 1
» Views: 80