Posts: 33
Threads: 15
Joined: Jan 2015
Reputation:
0
Home Port: Seattle
Vessel Info: 2005 Tiara 2900 Crusader 6.0L engines
I am seriously considering using this to clean out the raw water part of my 6.0L Crusader engines. I have done a lot of research but have not yet definitively determined whether the raw water impeller will be damaged. If it has to be removed then there must be another way to pump the mixture through the system.
Appreciate your thoughts on this.
Posts: 261
Threads: 9
Joined: Jul 2011
Reputation:
4
Home Port: Daytona Beach, FL
Vessel Info: 2000 Tiara 3500 Open
Cummins 6bta -370
01-24-2017, 07:26 PM
(This post was last modified: 01-24-2017, 07:27 PM by trit21.)
Barnacle Buster is just phosphoric acid, you can check the MSDS and the active chemical is phosphoric acid. Impellers should not be damaged by the acid especially phosphoric as it is a fairly weak acid. Phosphoric acid is what is used as a rust converter or rust remover. Typically the raw water pump is not used to circulate the cleaning agent through then engine. Another pump is used and a closed loop is created to recirculate the cleaning agent around the engine. The impeller is removed if you connected at the seacock side of the impeller housing.
Tom
Posts: 261
Threads: 9
Joined: Jul 2011
Reputation:
4
Home Port: Daytona Beach, FL
Vessel Info: 2000 Tiara 3500 Open
Cummins 6bta -370
I understand but the impeller would need to be removed as it will block the flow of cleaning agent.
Tom
Posts: 261
Threads: 9
Joined: Jul 2011
Reputation:
4
Home Port: Daytona Beach, FL
Vessel Info: 2000 Tiara 3500 Open
Cummins 6bta -370
That is not the most effective way of cleaning as there will many spots I would think that are not sitting in the cleaning solution. The best way is to create a closed loop system and circulate the cleaning agent for 2-3 hours then flush.
Tom
Posts: 53
Threads: 1
Joined: Jul 2015
Reputation:
1
Home Port: NJ
Vessel Info: 2001 Tiara 35 Open Cummins 370
I have done this a couple times. I bought a small bilge pump (360GPH?) and submerged the pump in a 5 gallon bucket filled with 2 gallons of RidLyme which is similar to BB. Hose from pump outlet went to the tranny/oil cooler inlet after removing hose from engine raw water pump to oil cooler. I also removed the HX outlet hose and installed a temporary hose from the HX output to the bucket. Let it run a couple hours. This also works well on the air conditioners.
Bob
Posts: 261
Threads: 9
Joined: Jul 2011
Reputation:
4
Home Port: Daytona Beach, FL
Vessel Info: 2000 Tiara 3500 Open
Cummins 6bta -370
Same basic set up I use except I use my old 800GPH pumps from my shower sump. I replace my shower sump once a year and the old pump goes to duty as acid flush. Works really well.
Tom