Posts: 80
Threads: 46
Joined: Dec 2011
Reputation:
0
2006 36' open qsb 380
I have five agm batteries three designated for the engines and two for the house and generator.
My house side batteries are two years old and lately after vessel sits at anchor for three or four hours the batteries go dead.
I load tested them after fully charged and they read ok.
i have the cabin refrig, the cockpit refrig. and electronics on for the period of time while at anchor, nothing more that I have used or the last five years?
Any thoughts or similar problem? thanks
Posts: 261
Threads: 9
Joined: Jul 2011
Reputation:
4
Home Port: Daytona Beach, FL
Vessel Info: 2000 Tiara 3500 Open
Cummins 6bta -370
When you say you tested them, how did you test them? Volt meter ? Load tester?
Tom
Posts: 8
Threads: 0
Joined: Oct 2017
Reputation:
0
Home Port: Long Island Sound
Vessel Info: Tiara 3500 Open
Cummins 370's
You sure about your configuration?
I have three house (starboard-front) and two engine (port rear) in my 3500/370 Cummins.
Posts: 80
Threads: 46
Joined: Dec 2011
Reputation:
0
I did a load test only.
Two batteries port side house
Three starboard side engines
Thanks
Posts: 486
Threads: 3
Joined: Apr 2013
Reputation:
20
Home Port: Lake Michigan
Vessel Info: 52 Sovran, Cat 3406
I've seen batteries that fall off quickly yet can still pass a load test when fully charged. I would first check that your charging system is operating correctly and configured for type AGM batteries. Improper charge rate/voltage can result in premature battery failure. After that an amp meter shoukd tell you if the problem is with the batteries or if you are drawing more current than expected.
Good luck
Posts: 80
Threads: 46
Joined: Dec 2011
Reputation:
0
I'm trying to identify two orange wires connected to the house batteries with twenty amp fuses. When the battery switch is off theses wires are hot, I first thought they were for the bilge pumps but they've are not. Thanks
Posts: 80
Threads: 46
Joined: Dec 2011
Reputation:
0
I'm experiencing a excess battery draw
Are those wires supposed to be hot. When I connect them to the battery with battery switch off I get a spark?
Posts: 38
Threads: 7
Joined: Mar 2018
Reputation:
0
Home Port: Lake Michigan
Vessel Info: 2004 35 Open 8.2L
I have the same issue with a 2004 35 open. I did zero in on the two in cabin Carbon Monoxide alarms being hard wired and drawing ~2 amps each. Not certain if this is the final culprit-I disconnected them from power to see. I will check later this week. Pls keep me informed and I will do the same.