[Ridin'High]

Hi I have a 2005 38 Open with the same remote start set up. My Generator is a Kohler but I would think the procedure would be the same. Try this, with the generator off I press the stop/start switch to the stop position for about 10 seconds or so for pre-heat. The switch turns yellow, at that point push the switch to the start position. This will begin the starting process. Hold the switch down, it may take more time than you might think. The switch should start to flash yellow till the engine starts. When it starts it will turn green. Be sure to hold the start switch till it turns a solid green and watch your gauge to insure your generator is putting out power. I have never had any issues with starting my generator using this procedure. Good Luck Tom