12-10-2018, 11:04 PM
Dennis, GCAT,
I know this is old post but I just discovered the same problem on my 2006 38 TTS. First a bolt from the hardtop bracket to the windshield snapped, then the welds in the cross brace cracked. Now the entire top has dropped about 3/8” so the bracket holes don’t line up with the windshield.
Tiara says they are a not aware of any issues with this design. They suggested that I shore up the top, remove the center support bracket, have the cross brace welded and reinstall. What they claim they didn’t realize is that the center support bracket is welded to the super structure above the windshield. I don’t want to cut out the center bracket. I also agree that X bracing would be a detractor.
I was trying to figure out a way to add lateral bracing in the form of aluminum plates on top of the hardtop. Attaching them by lenghting the bolts that attaché the hardtop to the super structure.
Has Tiara offered anyone a recommendation for this obvious design flaw?
Thank you,
Mark
I know this is old post but I just discovered the same problem on my 2006 38 TTS. First a bolt from the hardtop bracket to the windshield snapped, then the welds in the cross brace cracked. Now the entire top has dropped about 3/8” so the bracket holes don’t line up with the windshield.
Tiara says they are a not aware of any issues with this design. They suggested that I shore up the top, remove the center support bracket, have the cross brace welded and reinstall. What they claim they didn’t realize is that the center support bracket is welded to the super structure above the windshield. I don’t want to cut out the center bracket. I also agree that X bracing would be a detractor.
I was trying to figure out a way to add lateral bracing in the form of aluminum plates on top of the hardtop. Attaching them by lenghting the bolts that attaché the hardtop to the super structure.
Has Tiara offered anyone a recommendation for this obvious design flaw?
Thank you,
Mark

