Sounds like you have been working hard to find the leak... As I stated mine was a pin hole leak in the SS exhaust tube and I confirmed it prior to removing it as it was quite a job... I removed the front, left side (looking at the generator), & top sound shield covers to access the SS tube with my hands (couldn't see the tube)... I then started the Generator being careful not to put my hands any place I could get hurt.. I felt around and found the pin hole leak by feel only... Once I knew it was the SS tube I started the removal process... No special tools.. Used a 1/4" socket set, several screw drivers, and lots of determination.. Did remove the screws holding the fuel shutoff housing so it could be moved enough to loosen the right side sound shield cover...Removal of the tube itself was challenging as well.. Loosened the hose clamps between the exhaust manifold (on top left side facing generator) and the SS exhaust tube (be careful as there are sharp edges for the exhaust temp sensor as well as other sharp points). Once free I loosened the hose clamps on the SS exhaust tube to the exhaust hose itself (on right rear side of generator behind the fuel shut off housing... It now took 2 people to remove the SS pipe.. One working the SS pipe and the second holding the exhaust hose on the right rear side....As a note the tube goes through the sound shield on the rear right side of the sound shield so you will have to remove it by moving the tube to the right (toward the port side of boat) through the sound shield itself... Replacement is the reverse way, As I said its a challenge but it's the only way I saw to remove the SS exhaust tube.. Good Luck..M2C BTW thanks for the invite.... I will be in St Thomas 2/20 for a day as part of a cruise we are taking this winter...

