06-18-2013, 02:28 PM
Anthem,
What year is the 38 and do you have a Bowmar or Maxwell hatch?
Maxwell used some type of black sealant that seems to remain uncured and in the heat will actually expand and drip from the below the hatch.
I agree with all of the above suggestions and make sure of where the water is coming from first. If it is the seal between the aluminum and the acrylic, remove carefully, clean up the old adhesive (be careful as caustic chemicals will destroy the acrylic) and reinstall using a silicone based black caulking. Pre-tape the hatch when using the caulk, so your caulk lines will be perfect.
Good luck!
Sincerely,
What year is the 38 and do you have a Bowmar or Maxwell hatch?
Maxwell used some type of black sealant that seems to remain uncured and in the heat will actually expand and drip from the below the hatch.
I agree with all of the above suggestions and make sure of where the water is coming from first. If it is the seal between the aluminum and the acrylic, remove carefully, clean up the old adhesive (be careful as caustic chemicals will destroy the acrylic) and reinstall using a silicone based black caulking. Pre-tape the hatch when using the caulk, so your caulk lines will be perfect.
Good luck!
Sincerely,
![[Image: burkard-sig.jpg]](http://www.tiaraownersclub.com/images/burkard-sig.jpg)
