Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
36 open port light removal
#5
Use a metal putty knife sprayed with wd-40 a tap it with a small hammer behind the outer trim ring and the hull go in until it stops do this all the way around the porthole after that depending on how it was installed it may still take a good amount of pushing from the inside to get it to go.
Like Post Reply
  


Messages In This Thread
36 open port light removal - by Renegade93 - 12-04-2021, 04:44 PM
36 open port light removal - by Misdirection - 12-04-2021, 07:52 PM
RE: 36 open port light removal - by Renegade93 - 12-04-2021, 09:20 PM
36 open port light removal - by Misdirection - 12-05-2021, 09:00 AM
RE: 36 open port light removal - by reeltimebrad - 12-06-2021, 05:16 AM
RE: 36 open port light removal - by Renegade93 - 12-06-2021, 05:50 AM
RE: 36 open port light removal - by Dakota773 - 12-08-2021, 01:21 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  [Tiara Coronet] Port engineer and electronics quit running at same time Tmikac 1 48 4 hours ago
Last Post: Final Pursuit
  2001 38’ Open interior table base removal twilson0929 2 79 Today, 05:32 AM
Last Post: twilson0929
  1996 33Tiara open - shaft seal lubricant leaking Mydiamond 4 1,001 05-22-2026, 06:41 PM
Last Post: Mydiamond
  [Tiara Open] 2001 3800 Open Holding Tank cap that hold sensor and washdown twilson0929 0 603 05-12-2026, 10:18 AM
Last Post: twilson0929
  [Tiara Open] 1993 Open digitart 0 604 05-12-2026, 08:22 AM
Last Post: digitart



Users browsing this thread:
1 Guest(s)

36 open port light removal00