06-26-2023, 09:46 AM
Good morning,
I have run out of room to run wires on the STBD side of my radar arch. Looking from underneath in the engine bay, the hole between the arch and the hull is completely full and I need to run a few more sets through. My other option is to run down the PORT side through the factory channel. The wire goes in fine then hits a wall. Looking at it from underneath, it appears they never drilled a hole in the hull for wiring from the arch on the PORT side. When laying down on the exhaust system looking up, it's about 3' away and would be a tough job to drill that out.
Has anyone fought this battle before? Would love some insider information before I tackle this one.
Thanks!
I have run out of room to run wires on the STBD side of my radar arch. Looking from underneath in the engine bay, the hole between the arch and the hull is completely full and I need to run a few more sets through. My other option is to run down the PORT side through the factory channel. The wire goes in fine then hits a wall. Looking at it from underneath, it appears they never drilled a hole in the hull for wiring from the arch on the PORT side. When laying down on the exhaust system looking up, it's about 3' away and would be a tough job to drill that out.
Has anyone fought this battle before? Would love some insider information before I tackle this one.
Thanks!
