[sbw1]

Ok, I just picked up my icerette from my local boat repair shop . I wound up taking it to a shop that does the repairs . This wound up being more than what I wanted to mess with . The whole tray module had to be replaced and the icerettes gases had to be evacuated . I also removed the piece that the icerette gets screwed into , removed the old caulking and reinstalled it with the 5200 adhesive caulking . It's drying as I type this note . I also picked up a water charcoal activated filter to install in the 1/4" water line that feeds the unit. I have to give the adhesive a few days to dry before I slip the icerette back into its cubby hole but I'll be making my own ice in a few days .

Next job on the list , removal of the insulated box & disconnect the drain on the rear port side of the L shaped seat . Clean the old adhesive and caulking off and reinstall the box with the 5200 adhesive. .................Rich

Are you sure you want to use 5200 for this project. Might make any future service very difficult to perform.