04-20-2017, 02:06 PM
(04-15-2017, 07:13 PM)Uhehner Wrote: Why would you install plastic fittings when stainless are available at reasonable prices? UV light just destroys plastic.
Jus' wondrin' . Capt George
I'm not sure a stainless fitting exists for the scupper. Tiara used black plastic fittings that blend in with the boot stripe. So....it is replacing like for like plus it looks good. As far as the other through hulls, it really is a decision you would make on the basis of looks and durability. We replaced ours with plastic fittings that were painted with Imron to match the hull color. They look better than stainless in my view and the paint protects them from UV failure. Which ever you decide to use, it is important to check for moisture and make sure the install is done after the balsa core has been dried out and the area protected with epoxy prior to reinstalling the fittings. I have heard about several Tiaras in this area having wet cores where through hulls had been improperly installed by the factory. It is dissappointing to see this from a high end builder, and is an issue that merits review if own a Tiara or plan to purchase one.
