[bigboatben]

I have a 2015 Tiara 44 Coupe and would like to put a hard bottom inflatable on my hydraulic swim
platform and need your advise. Most of these are in the 500 -600lb range. My concern is that by doing this it will require me to change the factory props and potentially reduce our top cruising speed.
What have other owners done?

Hi Water Gate, the platform is good for 1000LBS. The largest size that fits properly is an 11.5’ with a 40hp. Tiara says the C44 is good for 30.5 knots but I see 33 knots out of them all the time without a tender, full fuel and fresh propspeed. It’s important to use the proper chocks. best to get the factory set up from nautical structures. You can talk to Bob Blue there and he will take care of you. The chocks used need to get the tender as low to the deck as possible. The NS system will do this for you. The nautical structures kit also lifts out with without having to be unbolted. Launch the boat, pull the chocks, throw them in the trunk and you can hang out and grill without stubbing a toe. Another consideration is dead rise of the tender. You don’t need to go with a flat bottomed tender but you also don’t want a super deep V tender on the C44. Issues arise when loading the tender in choppy conditions with a super deep V tender especially if you have the teak deak option. Find the middle ground on dead rise. If you want a sure fire fit go with the AB Mares 10’6” VSX. Refresh the propspeed on your props every year (make sure your diver knows how to care for propspeed) and if the boat is riding rough in chop try giving it more throttle before trying less. Just for fun I’ve attached pictures of the some C44s I’ve either had built or sold in the last year or so. Let me know if you need any further help! See you on the water!

bigboatben




Sent from my iPhone using Tapatalk