Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wobbly Table on 35 Open
#1
I have a 2004 35 open.  The table in the lower salon has wobble.  I think the plastic sleeve has worn out.  How do I remove the pedestal and is the sleeve available?  Is there another way to fix this?
Reply
#2
(05-11-2015, 12:16 PM)South Sound Steve Wrote: I have a 2004 35 open.  The table in the lower salon has wobble.  I think the plastic sleeve has worn out.  How do I remove the pedestal and is the sleeve available?  Is there another way to fix this?

Chances are the plastic sleeve has not worn out. I have the same table on a 2000 3500 Open. When you get to the boat here is what you need to do to determine the problem.

Unlatch the table so you would be able to spin it or push down. Notice on on the handle near that latch, on either side where the bolt is that holds the handle in place, there are 2 set screws. Screw them in just a little. Don't make them super tight as that will only damage the table locking mechanism. After turning them in, try to secure the latch again, so it will not spin. It should have tightened just a little but or maybe if you turned the set screws too much it is very tight. Adjust the set screws to set the table so it does not wobble. In other words, tighten, loosed, tighten until the table is not wobbly any longer but not too tight as this will cause undue stress on the clamp and eventually it may break. 

It that does not work, to remove the table you have to unscrew the base place from the floor, unscrew the wood table top from the the top mount and start removing piece until you get to the plastic piece, but there is nothing that causes the plastic piece to wear as the table mount has very little movement. I think the set screws should fix you right up. 
Tom
Reply
#3
I will give it a try
Reply
#4
Basically that pushes in the bolt which makes the plunger tighten up more on the table post which tightens it so it does not wobble. Should work. 
Tom
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  [Tiara Open] Unknown noise from Tiara 3800 Open engine room Tony Saitta 4 537 Yesterday, 01:54 PM
Last Post: liambrown
  [Tiara Open] 36' Open interior lights Rick B 0 69 11-14-2026, 12:22 PM
Last Post: Rick B
  38 open bathroom recessed light bulb twilson0929 3 659 08-26-2026, 06:22 AM
Last Post: twilson0929
  Replacement of Carbon Filter on vent line from Holding Tank. 38 Open ReelMagic 1 516 08-18-2026, 02:11 PM
Last Post: hiccup
  2001 38’ Open interior table base removal twilson0929 3 939 07-07-2026, 08:13 AM
Last Post: hiccup



Users browsing this thread: 1 Guest(s)
Advertisements

Latest Threads
3500 Open deck lift piston
Last Post: hiccup
Today 08:10 AM
» Replies: 4
» Views: 1101
Oil Filter ?
Last Post: ReelMagic
Yesterday 04:23 PM
» Replies: 7
» Views: 1619
Unknown noise from Tiara 3800 Open engi...
Last Post: liambrown
Yesterday 01:54 PM
» Replies: 4
» Views: 537
Tiara 40 Express 2003 - Removal of Cleat
Last Post: saywhen
11-14-2026 05:25 PM
» Replies: 2
» Views: 379
3500 Sovran trimtabs
Last Post: drprunner
11-14-2026 03:44 PM
» Replies: 0
» Views: 58