Posts: 140
Threads: 41
Joined: Jun 2013
Reputation:
0
Anyone know how to remove the front dash panel on a 1998 31 open without removeing the gauges
Posts: 16
Threads: 6
Joined: Nov 2015
Reputation:
0
Home Port: Dana Point
Vessel Info: 2001 3100 Opeb
Hi,
On my 2001 there are two screws on the top of the dash console near the front window. If you remove those screws the entire panel (gauges and all electronics tilts forward to allow for access to underside. Hope that answers your question.
Eric
Posts: 140
Threads: 41
Joined: Jun 2013
Reputation:
0
I want to remove the front panel with guage description so I can get it re silkscreened but was in hope that I wouldn't have to remove all the gauges to do so any ideas
Posts: 92
Threads: 14
Joined: Mar 2011
Reputation:
2
It's not possible to rescreen he panel without removing the gauges, the are raised above the surface making the screening impossible. It actually very easy to remove the gauges. Simply, press in (from the rear towards the front panel) and twist. Very similar to a child proof cap. Label each and you shouldn't have any issues.
Also, while the gauges are out, it's a good idea to remove and clean the lenses. They too simply pop off (there are 2 pieces and a o ring).
I too have the 98 31 and it's easy a pie.
Posts: 494
Threads: 22
Joined: Apr 2012
Reputation:
5
Home Port: Stuart, FL
Vessel Info: 1988 36' Convertible with new 8.1 Crusaders.
Exceptional condition, inside, outside, bilges and engines.
Just a suggestion. Take lots of close up pictures of the wiring with your digital camera. It will save you lots of headaches. I have seen lots of re-connection errors by people doing just what you want to do. Also make sure the battery switches are off. Sparks and arcs are not good. Capt. George
