Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Impeller failures
#1
Both of the impellers on my 2000, 3100 Open , have failed. Within days. Did not ground. What on earth could have caused this?
Could it be a failure in my flush out system? Water draining from the raw water intakes when I put the boat on the lift? I never run the engine dry.

Coppifan@aol.com
Reply
#2
Impellers wear out. When was the last time they were replaced? Cummins, for example, recommends replacing the impellers every 500 hours or every year.
Reply
#3
They're made out of rubber, at best, they only last 3 years or so.
-----------------------------------------------------------------
HarmoneE²
Tiara 3800 Open, Onset MA
Reply
#4
Impeller are a wearable item and should be changed regularly. I keep a spare set on the boat at all times

Since both engines usually are run about the same I always figure that if something goes bad on one the other is not far behind. I always buy 2 of everything and figure I will be using the other one fairly quickly.
Reply
#5
(05-07-2019, 07:05 AM)Coppifan Wrote: Both of the impellers on my 2000, 3100 Open , have failed. Within days. Did not ground. What on earth could have caused this?
Could it be a failure in my flush out system? Water draining from the raw water intakes when I put the boat on the lift? I never run the engine dry.

Coppifan@aol.com


Make sure you (or your mechanic) locates all the pieces! They can (and will) clog cooling passages.


Sent from my iPhone using Tapatalk
Reply
#6
(05-07-2019, 07:05 AM)Coppifan Wrote: Both of the impellers on my 2000, 3100 Open , have failed. Within days. Did not ground. What on earth could have caused this?
Could it be a failure in my flush out system? Water draining from the raw water intakes when I put the boat on the lift? I never run the engine dry.

Coppifan@aol.com


It takes a couple of seconds of dry running after you’ve been on the lift for water to run through the pump and start lubricating it.

Next time open the impeller cover and prelubricate the impeller. Liberal application of dishwashing liquid is how I do it. Use the opportunity to inspect your impeller!


Sent from my iPhone using Tapatalk
Reply
#7
by using the dish washing soap you not only lube the impellers but you can see the soap in the exhaust when started
Reply




Users browsing this thread: 1 Guest(s)
Advertisements

Latest Threads
3500 Open deck lift piston
Last Post: drmiagi11
Yesterday 12:51 PM
» Replies: 3
» Views: 1015
Hot Engine Room
Last Post: Nelsond
11-04-2026 11:36 AM
» Replies: 0
» Views: 56
Anyone using a cordless robot on a Tiara...
Last Post: thomasbrown
11-03-2026 05:08 PM
» Replies: 0
» Views: 58
Anyone using a cordless pool cleaner wit...
Last Post: hiccup
11-02-2026 01:18 PM
» Replies: 1
» Views: 92
Replacing the head on a Tiara 3100 — do ...
Last Post: hiccup
11-02-2026 01:17 PM
» Replies: 1
» Views: 80