Posts: 20
Threads: 11
Joined: May 2018
Reputation:
0
Home Port: LI Sound
Vessel Info: 2004 29 open, crusaders
need to change fluid and filters on hurth transmissions on 2004 29 open. any suggestions or advice before i start....seems pretty straight forward.
thanks
Posts: 398
Threads: 37
Joined: Jun 2020
Reputation:
3
Home Port: Annapolis, MD
Vessel Info: Currently looking
Pretty straightforward…remove old fluid, replace filter, refill.
You’ll have to make a decision on how to extract the old. You have the choice of using the drain and trying to catch it all or just suck it out of the top. Unless the boat is relatively new and you’re in fresh water, the drain plug will probably be hard to remove. So it’s easier to just get an extractor pump and suck it out through the dipstick.
Posts: 53
Threads: 1
Joined: Jul 2015
Reputation:
1
Home Port: NJ
Vessel Info: 2001 Tiara 35 Open Cummins 370
With my Borg Warners I would extract the fluid out of the tranny into a marked container so I would know how much fluid was removed. Makes refilling much quicker. Also, don't necessarily expect the same amount of fluid in two transmissions sitting side by side in identical engines. Bob
Posts: 398
Threads: 37
Joined: Jun 2020
Reputation:
3
Home Port: Annapolis, MD
Vessel Info: Currently looking
Like a mechanic buddy of mine used to say…just because they’re the same doesn’t mean they’re identical.
Posts: 44
Threads: 23
Joined: May 2021
Reputation:
0
Home Port: Lighthouse Point, FL
Vessel Info: 1993 3100 Open twin crusader 454s
I had a hard time with the filters. I had to buy 6 just to get 2 to fit.