Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tiara Open Westerbeke 5.0 BCDB
#1
Having issues with my generator.  Was shutting down after around 5 minutes and blowing 8 amp fuse on control box.  Changed all fueil and oil filters and engine oil.  Replaced oil pressure sensor and still no improvement.  
Last attempt however, ended with grinding sound, then sparks from the back end.  My guess from internet research is the bearing went and messed up the armature inside.  Would anyone with knowledge agree?
Reply
#2
I would call Hanson Maine - They are the Westerbeke guru's in the Northeast. Very helpful bunch. Doesn't sound good though. Good Luck! 781-631-3282
Reply
#3
(10-05-2024, 07:12 AM)Lobsta Wrote: I would call Hanson Maine - They are the Westerbeke guru's in the Northeast. Very helpful bunch. Doesn't sound good though. Good Luck! 781-631-3282

Thank you
Reply
#4
That is exactly how my back end went out. Windings were bad in the back of the generator at only 450 hours.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Westerbeke Generator no start Joeboch348 5 3,939 05-30-2024, 09:58 PM
Last Post: Joeboch348
  Westerbeke gas generator Sandy Bottom 4 4,889 09-01-2020, 09:22 AM
Last Post: Misdirection
  Westerbeke 5.0 BCG Question Snowballs 5 7,018 07-07-2018, 04:03 PM
Last Post: Snowballs



Users browsing this thread: 1 Guest(s)
Advertisements

Latest Threads
WTB Tiara Coronet (1997-2007)
Last Post: JaviAirstream
Today 02:09 PM
» Replies: 2
» Views: 70
3500 Open deck lift piston
Last Post: hiccup
Today 10:03 AM
» Replies: 6
» Views: 1158
How to Put Boat Picture On Left?
Last Post: hiccup
Today 09:58 AM
» Replies: 7
» Views: 4753
2000 3500 Open - Engine Sync Switch (7.4...
Last Post: liambrown
11-18-2026 05:48 PM
» Replies: 6
» Views: 2275
Hard Top for Tiara 3500 Open (1999) and ...
Last Post: joshuawhite
11-18-2026 02:48 PM
» Replies: 3
» Views: 494