Author's Statistic:
Posts: 67
Threads: 21
Likes Given: 0
Likes Received: 6 in 6 posts
Joined: Jan 2011
Home Port: Long Island, NY
Vessel Info: '95 3100 Open, Crusader 7.4's
Posts: 67
Threads: 21
Likes Given: 0
Likes Received: 6 in 6 posts
Joined: Jan 2011
Home Port: Long Island, NY
Vessel Info: '95 3100 Open, Crusader 7.4's
Author's Statistic:
Posts: 661
Threads: 11
Likes Given: 1
Likes Received: 89 in 81 posts
Joined: Dec 2010
Home Port: Kings Park, NY
Vessel Info: 2003 38' Open Cummin's 6CTA's (450 hp)
Posts: 661
Threads: 11
Likes Given: 1
Likes Received: 89 in 81 posts
Joined: Dec 2010
Home Port: Kings Park, NY
Vessel Info: 2003 38' Open Cummin's 6CTA's (450 hp)
On my 2003 38 Open the curved seat top is 2 pieces. One, the side piece, covers the top port side and the 2nd covers the piece facing aft... Both pieces are removed by opening the zipper on the bottom of the top pieces allowing access to bolts that hold the top pieces to the brackets supporting it....Your seat on the 31 may be different but assume it's somewhat the same Best I have.. M2C
Author's Statistic:
Posts: 67
Threads: 21
Likes Given: 0
Likes Received: 6 in 6 posts
Joined: Jan 2011
Home Port: Long Island, NY
Vessel Info: '95 3100 Open, Crusader 7.4's
Posts: 67
Threads: 21
Likes Given: 0
Likes Received: 6 in 6 posts
Joined: Jan 2011
Home Port: Long Island, NY
Vessel Info: '95 3100 Open, Crusader 7.4's
If I remember correct you will have to go under the seat inside the hatches and unbolt the bottom cushion first. Then you should have access to the brackets holding the back down.