10-07-2019, 06:14 PM
(This post was last modified: 10-07-2019, 06:14 PM by Misdirection.)
On my 36 the previous owner took two pieces of teak, maybe 2" x 4" and beveled the outside edge, drilled pilot holes and screwed them on thru the ceiling panel, I'm assuming to address a sagging issue. It blends right into the boat.
If I ever need to address a sagging, I think I would install teak rod holders on the ceiling panel. That way I'd solve two problems at once.
Just make sure your screws don't go all the way thru the fiberglass!
Sent from my SM-A505U using Tapatalk
If I ever need to address a sagging, I think I would install teak rod holders on the ceiling panel. That way I'd solve two problems at once.
Just make sure your screws don't go all the way thru the fiberglass!
Sent from my SM-A505U using Tapatalk

