Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PSS Shaft Seal Replacement/Drive shaft removal
#4
You have to remove the coupler nut and washer and then mount a puller on the coupler which drives the shaft out of the coupler same taper setup as a prop. It takes alot of pressure the puller plate needs to be 5/8 or thicker steel to not bend! Then apply heat to the coupler with Mapp gas it will need to get very hot and melt the paint off usually.
Reply


Messages In This Thread
RE: PSS Shaft Seal Replacement/Drive shaft removal - by reeltimebrad - 06-11-2020, 11:38 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Tiara 40 Express 2003 - Removal of Cleat saywhen 2 380 11-14-2026, 05:25 PM
Last Post: saywhen
  [Tiara Open] Cockpit bolster removal Rick B 0 60 11-14-2026, 12:15 PM
Last Post: Rick B
  Replacement of Carbon Filter on vent line from Holding Tank. 38 Open ReelMagic 1 516 08-18-2026, 02:11 PM
Last Post: hiccup
  [Tiara Open] Fireboy FE-241 replacement roboh20 0 481 07-25-2026, 09:15 AM
Last Post: roboh20
  2001 38’ Open interior table base removal twilson0929 3 939 07-07-2026, 08:13 AM
Last Post: hiccup



Users browsing this thread: 1 Guest(s)
Advertisements

Latest Threads
3500 Open deck lift piston
Last Post: hiccup
Today 08:10 AM
» Replies: 4
» Views: 1101
Oil Filter ?
Last Post: ReelMagic
Yesterday 04:23 PM
» Replies: 7
» Views: 1619
Unknown noise from Tiara 3800 Open engi...
Last Post: liambrown
Yesterday 01:54 PM
» Replies: 4
» Views: 537
Tiara 40 Express 2003 - Removal of Cleat
Last Post: saywhen
11-14-2026 05:25 PM
» Replies: 2
» Views: 380
3500 Sovran trimtabs
Last Post: drprunner
11-14-2026 03:44 PM
» Replies: 0
» Views: 58