I just replaced the one on my 2003 38 Open and it wasn't as bad as it looks....I marked each of the red cables so it would be easy to re-install once the new switch was in place.... Took a little doing to move the wiring looms giving access from the rear panel once removed.. Took 2 people to do the job, one in the engine room and the 2nd in the cabin so switch screws (under the steps) could be removed/replaced... Looks hard but if you take your time isn't. Took 30 minutes I would guess... Need a good socket set (1/4" or 3/8" and Philips screwdriver.. M2C

