04-01-2014, 07:45 AM
Wash
Wax
Bottom Paint
Check run out on the cutlass bearings
Clean the running gear
Don't forget to put the plug in.
Check and charge the batteries
Verify all fluid levels
Check the condition of all the hoses. At 10 years some may be showing signs. To me this is especially important for any
hose connected to a thru-hull.
Check all hose clamps.
How are the Raw water pumps? When was the last time the impellors were changed?
Heat Exchanger Zincs
Any zincs in the trans cooler?
I always make sure my engines start prior to launch, just don't do it dry.
This is a short list off the top of my head
Wax
Bottom Paint
Check run out on the cutlass bearings
Clean the running gear
Don't forget to put the plug in.
Check and charge the batteries
Verify all fluid levels
Check the condition of all the hoses. At 10 years some may be showing signs. To me this is especially important for any
hose connected to a thru-hull.
Check all hose clamps.
How are the Raw water pumps? When was the last time the impellors were changed?
Heat Exchanger Zincs
Any zincs in the trans cooler?
I always make sure my engines start prior to launch, just don't do it dry.
This is a short list off the top of my head
Mark - Reely Nauti
