12-16-2014, 12:40 PM
If you have never owned a vessel with an electric thruster, keep in mind that you only have about 5 to 7 seconds of thrust before you have to let off. Holding it longer will eventually overhead the circuit and cause you to lose the thruster completely until the circuit cools down. Avoid going from one direction to the other fast. Let the thruster prop come to a stop before switching directions, otherwise you will shear the cotter pin or break something else. They are great aids, but they have their limitations.
Larger vessels use hydraulic thrusters to overcome this limitation, but the cost is much higher.
As far as maneuvering sideways with just a bow thruster, it can be done, but takes a good amount of skill and quick hands on the clutches and thruster. With the time limitation of an electric thruster, you are only going to get so much sideways movement.
To move the vessel sideways to Starboard, Stbd. engine fwd/Port engine aft and thruster to Stbd. Do the opposite to move the vessel to Port. You have to be fast however to keep the boat from getting turned around on you.
Good Luck!
Larger vessels use hydraulic thrusters to overcome this limitation, but the cost is much higher.
As far as maneuvering sideways with just a bow thruster, it can be done, but takes a good amount of skill and quick hands on the clutches and thruster. With the time limitation of an electric thruster, you are only going to get so much sideways movement.
To move the vessel sideways to Starboard, Stbd. engine fwd/Port engine aft and thruster to Stbd. Do the opposite to move the vessel to Port. You have to be fast however to keep the boat from getting turned around on you.
Good Luck!


![[Image: burkard-sig.jpg]](http://www.tiaraownersclub.com/images/burkard-sig.jpg)