05-16-2015, 11:09 AM
(05-13-2015, 07:20 AM)Uhehner Wrote: Why not measure for your self? A protractor for the sweep and a ruler for the arm length and blade length. The post length can be taken off the old unit or measure the thickness of the windshield frame and call AFI. I doubt that this spec will be available anywhere except from Tiara. Capt. George
Thank you Capt George. Indeed your correct.
Tiara was able to provide me with the following information:
-------------------------
Original wiper specs (Tiara part number followed by vendor's if available):
3342290 motors, AFI GM2 37281 no longer made. I do not know sweep angle. We believe AFI 82182 to be a possible replacement, but this is unconfirmed.
3341940 arms, OEM only, $63.36 each
3341960 blades, OEM only, $40.96 each
-------------------------
The technical staff at Marinco AFI took my 1996 Tiara 3300 Open windshield photograph with dimensions and made the following recommendations for anyone else who may be of interest:
-------------------------
The motor you currently have is the AFI 2000. The replacement motor is the AFI 1.5, and is limited to arm length and blade length. The dimensions of the AFI 1.5 can be found in out catalog. [/url]http://www.delzer.com/powerproducts/globalmarinecatalog/#257/z
Based on the information you provided of a windshield 40.5” H X 28.5” W , and a AFI1.5 wiper motor with 2.5” shaft. The max height of the blade would be 22”, so you would not get the 6” from top and bottom for your line of sight. I would recommend the following:
Wiper motor part #71082 [url=http://www.marinco.com/en/71082]http://www.marinco.com/en/71082
wiper arm part #33037A http://www.marinco.com/en/33037a
wiper blade part #33022B http://www.marinco.com/en/33022b
If you have the room for an AFI 2.5 motor http://www.delzer.com/powerproducts/globalmarinecatalog/#256/z you can get a 24” blade.
Wiper motor part #82082 http://www.marinco.com/en/82082
wiper arm part #33092 http://www.marinco.com/en/33092
wiper blade part #33024S http://www.marinco.com/en/33024s
You may have to change the sweep angle of the motor you purchase for your application. All of our motors can be set to 45, 60, 80, or 110 degree sweep.
---------------------------
I hope that this may be helpful for someone else as well.
Best,
Scott
