[It's A Need]

2003 Open I just purchased has no indicator lights on the AC side of the panel.  AC is working fine, just no lights.  Is there a common ground or something else I should be looking at.  There is a switch to turn the DC indicator lights on/off.  It works.  Thoughts???

[MC1600]

Not sure about yours, but my 99 4000 has a switch on the breaker panel labeled “Panel Lights.”

[emarrero]

I had the same problem one day. DC worked but no indicators. Drove me up the wall!

   

[Jimmy]

2003 Open I just purchased has no indicator lights on the AC side of the panel.  AC is working fine, just no lights.  Is there a common ground or something else I should be looking at.  There is a switch to turn the DC indicator lights on/off.  It works.  Thoughts???

Most likely a ground issue on the panel , the lights get connected at the breaker and use a common ground to there respective system .
any work done should be done with the a/c and the dc powered down . use a test meter and check for resistance to ground .
You should not have any resistance . if so clean the grounds and reconnect . If no continuity at all  look for a broken wire.
Hope that helps . These are from my 1989 Tiara , had to replace all of the signal lamps on the 12 volt side as they were burnt out.
changed 2 breakers and added a new one at the same time.
All of the replaced lamps were changed to LEDS.