10-22-2016, 07:00 AM
I went down to the boat one weekend and found the original refrigerator was not working. Since it was 27 years old I decided to replace it and did not consider repair. The challenge began when trying to find a direct replacement, which I accomplished , and is the genesis for this thread.
I installed an Isotherm Elegance 130 which was about as close o a direct replacement I could find. I had to place some scrap strips of teak as shims underneath to hold it level. It protrudes a little further than the OEM one but does not interfere with the door to the head.
I hope that this solution can help someone in the future.
Cheers!
I installed an Isotherm Elegance 130 which was about as close o a direct replacement I could find. I had to place some scrap strips of teak as shims underneath to hold it level. It protrudes a little further than the OEM one but does not interfere with the door to the head.
I hope that this solution can help someone in the future.
Cheers!