Posts: 51
Threads: 14
Joined: Sep 2018
Reputation:
1
Home Port: Hope Port-Newport Beach, CA and we boat in So Cal and Northern Baja.
Vessel Info: 2002 4100 Open, Cats 3126B 450 HP.
Hey All,
I have the 3126B engines and I recently changed the oil and I think I broke a wire to the engine monitoring system as it is not reading the RPM's or oil pressure. I tried looking for obvious lose wires with no luck. Any advised would be greatly appreciated.
Thanks,
Tim
Posts: 51
Threads: 14
Joined: Sep 2018
Reputation:
1
Home Port: Hope Port-Newport Beach, CA and we boat in So Cal and Northern Baja.
Vessel Info: 2002 4100 Open, Cats 3126B 450 HP.
Thanks for the advice. I swapped the wires to the monitors and they are okay, which means its in the wiring. I wish I had a schematic of the wiring harness to identify each wire.
Posts: 486
Threads: 3
Joined: Apr 2013
Reputation:
20
Home Port: Lake Michigan
Vessel Info: 52 Sovran, Cat 3406
What wires are you looking for? Assuming you have an MPD display (single screen 9" monitor) engine data travels over J1939 which is a 2 wire + shield canbus network. These connections should be on pins 16,17 and 18 of your customer connector.
If you you switched wiring over and the problem followed the wiring, and you are getting some but not all data on the display (only some instruments) then it is possible you have a problem with the ECM. Did your display show a "J1939 signal loss" error before loosing engine speed and OP?