Tiara Open 2006 36 Open Racors
#1
I recently purchased a low hour 2006 36 Open with Cummins 425s in it. With 380 all fresh water hours. I tok her to Long Island NY via Saint Lawrence River, Lake Ontario and the Oswego and Erie Canals to the Hudson River. It started a mild surge so I changed the razor filters. On my last boat I would close the supply valves and run the engines for a few second to drain down the racors and not spill any fuel. I did the same with this boat but fuel was still flowing into the filters and the bilge. I guess it is possible the valve diagram is not correct but maybe I am missing a secret to do this neatly. Ideas?
Reply
#2
Racors shouldn’t “drain down” when you close the supply valve. If it did that on your old boat, the Racors had a leak allowing air in under strong vacuum. What you were doing is not a recommended procedure. Get a bucket that fits underneath.


Sent from my iPhone using Tapatalk
Reply
#3
Agree with JMK.
Reply
#4
(08-11-2023, 11:45 PM)jmk Wrote: Racors shouldn’t “drain down” when you close the supply valve.  If it did that on your old boat, the Racors had a leak allowing air in under strong vacuum.  What you were doing is not a recommended procedure.  Get a bucket that fits underneath.


Sent from my iPhone using Tapatalk

It did not drain down. The fuel kept flowing into the uncovered filter even with the supply valves labeled from the factory closed.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  [Tiara Open] Unknown noise from Tiara 3800 Open engine room Tony Saitta 4 612 11-16-2026, 01:54 PM
Last Post: liambrown
  [Tiara Open] 36' Open interior lights Rick B 0 103 11-14-2026, 12:22 PM
Last Post: Rick B
  38 open bathroom recessed light bulb twilson0929 3 706 08-26-2026, 06:22 AM
Last Post: twilson0929
  Replacement of Carbon Filter on vent line from Holding Tank. 38 Open ReelMagic 1 545 08-18-2026, 02:11 PM
Last Post: hiccup
  2001 38’ Open interior table base removal twilson0929 3 986 07-07-2026, 08:13 AM
Last Post: hiccup



Users browsing this thread: 1 Guest(s)
Advertisements

>