Reinstalling power vent in windshield. 1993 3100 open
#1
I removed the powered vent in my windshield to replace the weather stripping. It just lifted right out after disconnecting the power actuator. Now I cannot get the window back in. Anyone have suggestions? There's no hinge, just a curved lip that should go back in but doesn't.
Reply
#2
This is a known challenge. At the factory they put the center window into the windshield assembly before it goes on the boat. Once the windshield is attached to the boat it becomes slightly curved as it is fastened. Two people, trying to get the angle just right, and lots of patience. I have heard a ratchet strap wrapped around the frame and window can help provide the necessary persuasion. Good luck.
Reply
#3
Was this removing the center windshield altogether or just disconnecting it from the actuator? I have to replace my actuator soon and have not been looking forward to that project. This is more rain on the parade.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  [Tiara Open] Unknown noise from Tiara 3800 Open engine room Tony Saitta 4 608 11-16-2026, 01:54 PM
Last Post: liambrown
  [Tiara Open] 36' Open interior lights Rick B 0 101 11-14-2026, 12:22 PM
Last Post: Rick B
  Looking for Help with Fuel Vent Issue - Tiara 2700 (1988) kahunamax 3 627 10-02-2026, 11:50 AM
Last Post: kahunamax
  Windshield Leak tip TIARACRREP 35 42,423 09-23-2026, 11:53 AM
Last Post: dlombardozzi@comcast.net
  38 open bathroom recessed light bulb twilson0929 3 705 08-26-2026, 06:22 AM
Last Post: twilson0929



Users browsing this thread: 2 Guest(s)
Advertisements

>