[Ohana John]

I own a 2001 Coronet that I purchased last year. This is the first year that I'm purchasing Zincs for the boat. Does any one have a list of the zincs needed?



Sent from my iPhone using Tapatalk

[rafredrickson]

E1 pencil for the engines, E0 for the genny, 1/1/2' shafts, and 5 bolt center plates for thetransom

[stugiv]

I have a '97 so I'm not sure if there were any changes.

I use E0 pencil zincs on the U cooler & E1 for the heat exchanger. My hull zincs are CMMZC406, which is the Martyr part #. Not sure what the generic size is. I also added some BNT-1 zincs on the Bennet trim tabs because I was having some electrolysis problems.