05-30-2018, 01:31 PM
Matta has good advice here. Especially if your old pump was self priming and the new one is not.
Sent from my XT1635-01 using Tapatalk
(05-30-2018, 09:10 AM)Matta0413 Wrote: Are you priming the system? Sot sure where you seastrainer is but mine is hard plumbed right to the intake side of the pump. Take the cover off the seastrainer and slowly open the seacock until water over flows out of the top of the seastrainer. Then put the cap back on, and fully open the seastrainer. Did you say the Tech bench tested the pump and had the same symptom? Just a click and then nothing?
Sent from my XT1635-01 using Tapatalk


![[-]](https://www.tiaraownersclub.com/forum/images/netpen-pro/collapse.png)