[Free Spool]

I need advice on removing salon door to replace a bad refrigerator.  Anyone have any experience on getting door off?  Unfortunately the fridge is an inch wider than door opening with slide doors fully open. 
May need to remove doors???

[jclark003]

Did you measure with door removed from refrigerator?

Not sure on your year how to remove slider. If I remember correctly on my older 43 it required removing a pretty large panel that the slider hides behind when in the open position. Not a terrible job but not easy either. I would recommend reaching out to Tiara customer support. They usually have service bulletins for such projects.

[Free Spool]

Did you measure with door removed from refrigerator?

Not sure on your year how to remove slider. If I remember correctly on my older 43 it required removing a pretty large panel that the slider hides behind when in the open position. Not a terrible job but not easy either. I would recommend reaching out to Tiara customer support. They usually have service bulletins for such projects.

---

Thanks for the reply.
I took out the drawers and I’m needing another inch or two. From what I could see it’s seems exactly as you stated. Looks like a large panel would need to be removed. It did look doable but would be a project. I was hoping there might be a trick to it.
I sent an email to A contact I have in their customer support. Hopefully they have a tech bulletin that will make it easier. As much as I’d like to replace it, I might be having it fixed inside the salon to avoid the aggravation.

[rmsullivan1@gmail.com]

Did you measure with door removed from refrigerator?

Not sure on your year how to remove slider. If I remember correctly on my older 43 it required removing a pretty large panel that the slider hides behind when in the open position. Not a terrible job but not easy either. I would recommend reaching out to Tiara customer support. They usually have service bulletins for such projects.

---

Thanks for the reply.
I took out the drawers and I’m needing another inch or two.  From what I could see it’s seems exactly as you stated.  Looks like a large panel would need to be removed.  It did look doable but would be a project.  I was hoping there might be a trick to it.
I sent an email to A contact I have in their customer support.  Hopefully they have a tech bulletin that will make it easier. As much as I’d like to replace it, I might be having it fixed inside the salon to avoid the aggravation.

---

Hello, I’m looking at a number of used 43 Opens and am interested in your experience with regard to forward visibility and noise level underway. Mike S (2006 3600 Open)