Radar install
#1
I own a 29 tiara with a hard top, and I'm installing a radar. The cable for the radar dome comes with connectors already installed. Which makes it very difficult to fish the cable through tubing of the hard top supports. Has anyone have or had this problem? And can the cable be cut  and spliced, which would make the install much easierl.
Reply
#2
 DO NOT CUT the cable!!!!!!!!   DO NOT CUT the cable!!!!!!!!   DO NOT CUT the cable!!!!!!!!
I'll bet the cable can be disconnected from the terminal board in the dome, wrapped with tape and pulled up the pipe from the bottom.
I did not say it was easy but cutting and splicing is major surgery.
Capt.  George
Reply
#3
Thanks Cap. George, The cable has several connectors on the dome end. I'll try to remove the connector pins from the connector and tape up all the wires. And your 100 percent correct, it's not going to be easy. I just hope I don't break off any of the connector pins from the wires.

(05-31-2015, 03:49 PM)Uhehner Wrote:  DO NOT CUT the cable!!!!!!!!   DO NOT CUT the cable!!!!!!!!   DO NOT CUT the cable!!!!!!!!
I'll bet the cable can be disconnected from the terminal board in the dome, wrapped with tape and pulled up the pipe from the bottom.
I did not say it was easy but cutting and splicing is major surgery.
Capt.  George
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  2000 3500 Express Raymarine c120 Radar Replacement - Ohio River JMGCINCY2023 5 8,830 09-02-2025, 10:06 AM
Last Post: sluggo
  Radar error code 6, autopilot ECU circuit overload d5dekeyser 2 2,237 06-30-2024, 08:58 PM
Last Post: jclark003
  [Tiara Open] Advice on Radar/electronics Fuggly 0 2,308 01-07-2024, 07:38 PM
Last Post: Fuggly
  Garmin Radar firstlight 1 2,311 06-28-2023, 12:57 PM
Last Post: ReelMagic
  Furuno radar removal-opinion North000 5 4,091 04-13-2023, 09:13 AM
Last Post: RCKLAW



Users browsing this thread: 1 Guest(s)
Advertisements

>