Posts: 8
Threads: 3
Joined: Jul 2020
Reputation:
0
Home Port: Portsmouth, Va
Vessel Info: Express 4000 1995
While docking yesterday my starboard engine got stuck in reverse.
I think it’s the cable because nothing moves on the engine room while operating the level.
Anyway to test it better?
Am I supposed to be able to manually shift the transmission in the engine room?
Mine is a 95 4000 Express will Cummins
Thanks
Mario
Posts: 481
Threads: 8
Joined: Apr 2018
Reputation:
10
Home Port: Port Canaveral, FL
Vessel Info: 2003 Tiara 50 Open
3406E Cats
The cable should move the lever on top of the transmission. If you are looking at the shift lever and some moves the gear levers up top and nothing moves on the trans, I would start with the shift housing on the helm and start back from there.
You can shift manually with the lever to get you home but it could get dangerous around the dock.
Posts: 463
Threads: 3
Joined: May 2018
Reputation:
7
Home Port: Ashtabula, OH
Vessel Info: 1986 Tiara 3600 Open, Crusader 454's
I would recommend disconnecting the shift cable from the transmission and have someone at the helm work the lever. Then you can also manually try and shift the transmission. That should help rule out one or another as well.
Sent from my SM-A505U using Tapatalk
Posts: 486
Threads: 3
Joined: Apr 2013
Reputation:
20
Home Port: Lake Michigan
Vessel Info: 52 Sovran, Cat 3406
I just went through this with a friends 43. The morose control head has a cast aluminum pivot arm that actuates the cable. On his the casting failed and the gear would no longer shift. Fortunately the controls are setup for dual station so the fix was simple and involved switching the cable to the other side of the arm. Pop the cover off the shifter assembly and take a look. should be obvious if the mechanism failed. If not time for a new cable.
Posts: 481
Threads: 8
Joined: Apr 2018
Reputation:
10
Home Port: Port Canaveral, FL
Vessel Info: 2003 Tiara 50 Open
3406E Cats
Did you disconnect the cable from the transmission before you tried to move the shifting arm?
If the cable is bad or the control is stuck then you aren't going to be able to move the arm with the cable attached.
Remove the cable. If the shift arm moves its the cable or morse control. If the arm still doesnt move but the cable does its the transmission.