Moisture around porthole windows
#11
I've read about the boatdry system, never had a need for it.

I was able to reuse 5 out of 6 gaskets last time I did mine, but I knew #6 needed replaced before I started.

Sent from my SM-A505U using Tapatalk
Reply
#12
I also was told by the surveyor that the readings around port side portal forward was a little high. Seems like common issue. I'll look for the you tube vids and take a crack at it in the spring.
Reply
#13
For the moisture around the anchor locker, you can drill a sparse matrix of 1/4” holes on the underside of the laminate without compromising the structure. Then over time (years) the area will dry out.

For the wet foam under the port light, I assume you mean the cabin trim not the hull laminate. Yes, you can let that dry out.

When rebedding the port light frames, I do NOT recommend using 3M 4000UV. Over time, it simply disappears. I’d probably now use 3M marine silicone after cleaning all surfaces with acetone.


Sent from my iPhone using Tapatalk
Reply
#14
I am wondering how much silicon I should use on the port hole frame when installing a new gasket? Does one put a small bead around the track jusr so it will stick or a larger bead spread around to cover the entire track's area?

I have the recommended Dow 732 silicon.

I bought some caulk/silicon remover spray at ACE Hardware that is to remove it in pieces rather than dissolve the old silicon. Anything work better?
Reply
#15
When removing and cleaning up the old silicon, paint thinner worked really good.

I was very generous with the bead, and cleaned up the excess.

Sent from my SM-A505U using Tapatalk
Reply
#16
I just got new seals/screens from Tiara and they sent an entire tube (squeeze tube, not caulk gun size) for each porthole. So I’m presuming they want a good bit on each.
Reply
#17
(11-13-2021, 12:36 AM)MC1600 Wrote: I just got new seals/screens from Tiara and they sent an entire tube (squeeze tube, not caulk gun size) for each porthole. So I’m presuming they want a good bit on each.

Did your kit have seals and screens or were the screens embedded in the seals?
Reply
#18
My kit from GG Schmitt came with the gasket and screen as separate pieces.

Sent from my SM-A505U using Tapatalk
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  [Tiara Sovran] Porthole Screens robwhite433@yahoo.com 3 3,924 02-13-2024, 12:19 PM
Last Post: Narrowriver
  [Tiara Sovran] Stuck bathroom porthole Donaldjames 0 968 03-09-2023, 10:11 AM
Last Post: Donaldjames
  [Tiara Open] Porthole Locks Joeboch348 1 1,516 02-18-2023, 09:42 AM
Last Post: bruce@bigrivergroup.com
  Moisture Steve L 3 2,776 05-02-2022, 11:56 AM
Last Post: hiccup
  Wrong Porthole Gaskets? MC1600 6 5,304 04-11-2022, 10:30 AM
Last Post: MC1600



Users browsing this thread: 1 Guest(s)
Advertisements

>