10-15-2023, 01:42 PM
Posting for information…
My port engine started to crank but not turn over.
No spark from coil to distributor.
Checking posts there were suggestion to;
Change coil
Change rotor
Distributor
Change spark plug and wires
Battery
Etc.
When I jiggled the wire from alternator to coil… the engine would sometimes start.
As I took off the distributor cap and traced the wire, there is a small black piece. I think it’s called the distributor pick up. ( not sure) at the base of the distributor.
Took the two screws out and found it was plugged in to the distributor via a wire connection. This plug was very loose.
Tightened connections… replace piece (just in case). And put back together.
Started right away.
$40.00 piece and was not in any of my on line searches.
I hope it helps someone…
My port engine started to crank but not turn over.
No spark from coil to distributor.
Checking posts there were suggestion to;
Change coil
Change rotor
Distributor
Change spark plug and wires
Battery
Etc.
When I jiggled the wire from alternator to coil… the engine would sometimes start.
As I took off the distributor cap and traced the wire, there is a small black piece. I think it’s called the distributor pick up. ( not sure) at the base of the distributor.
Took the two screws out and found it was plugged in to the distributor via a wire connection. This plug was very loose.
Tightened connections… replace piece (just in case). And put back together.
Started right away.
$40.00 piece and was not in any of my on line searches.
I hope it helps someone…